No more sewage smells creeping through your house. No more rust-colored water. No more calling a plumber every few months because another section failed.
When your cast iron sewer pipe replacement is done, your water pressure improves immediately. Showers run clear and strong. Drains empty the way they’re supposed to.
Your floors stay intact. Your landscaping doesn’t get destroyed. The work happens faster than you’d expect because we’re not digging trenches across your yard or jackhammering through your foundation.
And if you’re thinking about selling, updated plumbing isn’t just a checkbox—it’s one of the first things buyers and inspectors look for. Especially in Florida, where insurance companies are getting pickier about covering homes with old cast iron systems.
Drain Wizard has spent over forty years working on Florida homes. We know what humidity and salt air do to cast iron. We know how fast corrosion spreads once it starts.
Most homes in Rockwell built before 1975 still have original cast iron pipes. That means you’re dealing with systems that are fifty years old or more—well past their functional lifespan. If one section is failing, the rest isn’t far behind.
We’re licensed and insured to work throughout Florida. Our crews use hydro excavation and trenchless methods that keep disruption low and results reliable. You’re not getting a national franchise with rotating techs—you’re working with local specialists who understand what’s happening under your property.
We start with a camera inspection. That shows us exactly where the corrosion is, how bad it’s gotten, and what sections need replacing. No guessing.
From there, we map out the most efficient route to access your pipes—usually through existing cleanouts or small access points. If we need to dig, we use hydro excavation to minimize the footprint. That means targeted, precise work instead of ripping up your entire yard.
Once we’re in, the old cast iron comes out and gets replaced with PVC or PEX. These materials don’t corrode, don’t rust, and handle Florida’s climate without breaking down. The installation is supervised by licensed engineers, so you’re getting work that meets code and lasts.
Most residential sewer line replacement projects wrap up in a few days. You’ll have some minor disruption—access points, equipment on-site—but nothing like traditional dig-and-replace jobs. When we’re done, your plumbing works the way it should, and your property looks normal again.
Ready to get started?
You get a full assessment before any work starts. We document the condition of your entire system—not just the problem area—so there are no surprises later.
The replacement itself covers all failing sections. We don’t patch over corrosion or try to extend the life of pipes that are already compromised. If it’s bad, it gets replaced with modern materials that won’t fail in five years.
In Rockwell and across Central Florida, we’re seeing more homeowners move proactively instead of waiting for a catastrophic failure. That’s smart. Replacing cast iron before it ruptures saves you from emergency pricing, water damage, and the chaos of a sudden breakdown.
We also handle pipe descaling for systems that aren’t fully failing yet but have heavy buildup affecting flow. That’s a stopgap, though. If your pipes are from the ’70s or earlier, descaling buys you time—it doesn’t solve the underlying corrosion. Most homeowners in that situation end up replacing within a year or two anyway.
Recurring backups are the biggest red flag. If you’re calling a plumber every few months for the same issue, that’s not bad luck—that’s a failing system.
Other signs include slow drains throughout the house, sewage odors that won’t go away, rust-colored water, or visible cracks in your foundation. You might also notice patches of extra-green grass in your yard where a pipe is leaking underground.
If your home was built before 1975 and still has the original plumbing, you’re on borrowed time. Cast iron pipes typically last 50 to 60 years in ideal conditions. In Florida’s humid, salty environment, they start breaking down closer to 25 or 30 years. Once corrosion starts, it spreads fast.
Traditional replacement means digging trenches across your property to access the pipes. That destroys landscaping, driveways, and sometimes floors if the pipes run under your house. It’s expensive, slow, and messy.
Trenchless sewer repair uses existing access points or small, targeted excavations. We either line the inside of the old pipe with a new epoxy coating, or we use hydro excavation to pull new pipes through without tearing everything up. The result is the same—new, functional plumbing—but the process is faster and way less destructive.
For most Rockwell homes, trenchless methods cost about a quarter of what traditional replacement runs. You’re not paying for days of labor, heavy equipment, and restoration work afterward. The job gets done in a fraction of the time, and your property stays intact.
Probably not. Florida insurers have been tightening restrictions on older plumbing systems, and many policies now specifically exclude coverage for cast iron pipe failures.
If the failure causes sudden, visible damage—like a burst pipe flooding your house—you might get coverage for the water damage itself. But the cost to replace the pipes usually falls on you. Insurance treats that as maintenance, not a covered loss.
Some policies will cover you if the damage is “sudden and accidental,” but that’s a gray area. If the pipes have been slowly corroding for years, the insurer can argue it’s a maintenance issue you should’ve addressed earlier. That’s why more homeowners are replacing cast iron proactively instead of waiting for it to fail and hoping insurance picks up the tab.
Most residential jobs take two to four days, depending on how much pipe needs replacing and how accessible it is. If we’re using trenchless methods and the layout is straightforward, you’re looking at the shorter end of that range.
Traditional dig-and-replace jobs take longer—sometimes a week or more—because of the excavation and restoration work. That’s one reason trenchless is becoming the standard in Florida. Less time, less mess, same result.
During the work, you’ll have limited access to certain drains and fixtures. We’ll walk you through what’s available and what’s not before we start. Most people are surprised by how little disruption there actually is, especially compared to what they were expecting.
You can, but it’s usually a short-term fix. If one section of your cast iron system has corroded enough to fail, the rest of the pipes are in similar condition. They were all installed at the same time, exposed to the same conditions, and aging at the same rate.
Replacing just the bad section might buy you six months or a year. Then another section fails. And another. You end up paying for multiple service calls, multiple repairs, and a lot of frustration.
Most homeowners who go the piecemeal route eventually replace the whole system anyway—they just spend more money getting there. If your pipes are old enough to be failing, it makes more sense to handle it all at once. One project, one cost, and you’re done.
We typically use PVC or PEX, depending on the application. Both are durable, corrosion-resistant, and handle Florida’s climate without breaking down the way cast iron does.
PVC is the standard for sewer lines. It’s strong, affordable, and lasts decades without maintenance. PEX is more common for water supply lines because it’s flexible and easier to route through tight spaces.
Neither material rusts, cracks from corrosion, or develops the buildup issues you see with old cast iron. Water flows better, pressure stays consistent, and you’re not dealing with the same recurring problems. These are the materials we use in new construction across Florida—they’re proven, reliable, and built to last.
Local Resources
Useful Links
